Chapter Effects Breast and Prostate Cancer Metastases on Lumbar Spine Biomechanics: Rapid In Silico Evaluation, Lorkowski J., Grzegorowska O., Kozień M., Kotela I.In: Advances in Experimental Medicine and Biology (2018). Springer, New York, NY.
Metastases to distant organs are a frequent occurrence in cancer diseases. The skeletal system, especially the spine, is one such organ. The objective of this study was to apply a numerical modeling, using a finite element method (FEM), for the evaluation of deformation and stress in lumbar spine in bone metastases to the spine. We investigated 20 patients (10 women and 10 men) aged 38–81 years. In women, osteolytic lesions in lumbar spine accompanied breast cancer, in men it was prostate cancer. Geometry of FEM models were built based on CT scans of metastatic lumbar spine. We made the models for osteolytic metastases, osteosclerotic metastases, and metastases after surgery. Images were compared. We found a considerable concentration of strain, especially located in the posterior part of the vertebral body. In osteolytic lesions, the strain was located below the vertebral body with metastases. In osteosclerotic lesions, the strain was located in the anterior and posterior parts in and below the vertebral body with metastases. Surgery abolished the pathological strain. We conclude that metastases to the lumbar spine introduce a pathological strain on the lumbar body. The immobilization of the vertebral body around fractures abolished the strain.
Peak stresses shift from femoral tunnel aperture to tibial tunnel aperture in lateral tibial tunnel ACL reconstructions: a 3D graft-bending angle measurement and finite-element analysis, by Van Der Bracht et al. KSSTA (2018) 26(2): 508–517.
To investigate the effect of tibial tunnel orientation on graft-bending angle and stress distribution in the ACL graft.
Eight cadaveric knees were scanned in extension, 45°, 90°, and full flexion. 3D reconstructions with anatomically placed anterior cruciate ligament (ACL) grafts were constructed with Mimics 14.12®. 3D graft-bending angles were measured for classic medial tibial tunnels (MTT) and lateral tibial tunnels (LTT) with different drill-guide angles (DGA) (45°, 55°, 65°, and 75°). A pivot shift was performed on 1 knee in a finite-element analysis. The peak stresses in the graft were calculated for eight different tibial tunnel orientations.
In a classic anatomical ACL repair, the largest graft-bending angle and peak stresses are seen at the femoral tunnel aperture. The use of a different DGA at the tibial side does not change the graft-bending angle at the femoral side or magnitude of peak stresses significantly. When using LTT, the largest graft-bending angles and peak stresses are seen at the tibial tunnel aperture.
In a classic anatomical ACL repair, peak stresses in the ACL graft are found at the femoral tunnel aperture. When an LTT is used, peak stresses are similar compared to classic ACL repairs, but the location of the peak stress will shift from the femoral tunnel aperture towards the tibial tunnel aperture. Clinical relevance: the risk of graft rupture is similar for both MTTs and LTTs, but the location of graft rupture changes from the femoral tunnel aperture towards the tibial tunnel aperture, respectively.